Configuring an Emulex HBA

1. Install the SUN StorEdge SAN 4.4.x pkg

2. Reboot the system.

3. Check the configuration before SAN configuration.
# cfgadm -o show_FCP_dev -al

4. Configure SAN
# cfgadm -c configure c3

5. Verify configuration
# cfgadm -al

Verify that "/etc/cfg/fp/fabric_WWN_map" contains all fabric devices required.

How to configure new EMC lun

1. If lun addresses are NOT in /kernel/drv/sd.conf:
- add new lun addresses at the proper target
- Do touch /reconfigure
- Do a reboot

2. If lun addresses were already in sd.conf:
- devfsadm

3. If using powerpath :
- /etc/powercf -q
- /etc/powermt load
- /etc/powermt config

4. Now run 'format' to put a label on the disks

5. Do 'vxdctl enable' to allow veritas to rescan the devices

6. Use vxdisksetup/vxdiskadd/veritas gui etc. to bring the new disk into
veritas control